Introduction

On March 16, FDA announced a massive recall of pet food, affecting 95 brands of both dog and cat foods. The foods appeared to be causing renal failure in some animals, leading to at least 15 confirmed deaths. The recall has since expanded to cover over 100 brands of both dry and wet food, and the anecdotal death total is in the hundreds.

Initial reports from a New York laboratory indicated the presence of aminopterin, a rat poison and experimental cancer drug. Later reports from FDA could not confirm this finding, although they did announce that they had found melamine, an industrial chemical used in the production of plastics and fertilizers, among other things.

The melamine method is based upon LC-MS/MS and is sensitive to approximately  0.5 ug/g.  The aminopterin method is also based on  LC-MS/MS, and is sensitive to approximately 0.05 ug/g. We have successfully used both of these methods to analyze both dog and cat foods.

FDA Pet Food Recall Home

FDA Update and Synopsis

For a quotation...

Melamine

Melamine may have been used to increase the apparent protein assay of wheat gluten, a food additive.  If so, melamine would have been added at relatively high levels (%).

On April 5, 2007, FDA reported that melamine was found in 21 out of 400 samples tested.  FDA also posted methods used in testing based upon GCMS of TMS derivatives (screening test, not quantitative) and an HPLC-UV test.  Neither of these methods are considered both specific and quantitative for melamine in complex samples like pet food.

USA Today

FDA GC Method

FDA HPLC-UV Method

Aminopterin

Aminopterin is a cancer drug and rodenticide (rat poison).  It was the toxin initially suspected in the March 2007 recall of pet foods.  Use as a rat poison is banned in the US but not in China.  The suspected origin is wheat gluten, a food additive.

Wikipedia

ABC News

Testing for Melamine and Aminopterin 

Pet food samples are extracted into water. These water extracts are filtered, then analyzed by LC-MS/MS without further treatment.

Ionization is accomplished using an electrospray interface. MS/MS is carried out in the positive ion mode, monitoring various transitions from the  molecular ions.

9240 Santa Fe Springs Rd
Santa Fe Springs, CA 90670

info-wcas@bodycote.com

562.948.2225 Fax 562.948.5850